Cookies på Omegas websteder Vi anvender cookies på vores websted. Disse cookies er afgørende for, at webstedet kan fungere korrekt. Hvis du fortsætter uden at ændre dine indstillinger, antager vi, at du gerne vil modtage alle de cookies, der anvendes på dette websted. Du finder flere oplysninger om cookies ved at klikke her
Click on this link if you need more information about an accelerometer.
The ACC102A accelerometer uses a shear mode design for high performance. It has a rugged stainless steel inner structure covered by a moulded polymer. This construction makes the ACC102A impervious to harsh environments, such as alkaline coolants, hot oil and water sprays, resulting in long, reliable service. Additional features include high shock protection (to protect from dropping or mishandling), cross wire protection (protects against mis-wiring), and up to 1000 volt static discharge protection.
The ACC102A has a high 100 mV/g output and measures across wide frequency and acceleration ranges. A low impedance cable allows for runs up to 300 metres. The ACC102A exhibits the low noise floor and high amplitude linearity you’d expect in more expensive units.
SPECIFICATIONS Excitation: 2 mA @ 24 to 30 Vdc, constant current (18 V supply can be used but will limit amplitude range) Rated Output: 100 mV/g nominal at 100 Hz Frequency Range: 3 Hz to 5 kHz (up to ±5% rated output shift) Amplitude Range: ±75 g peak with ACC-PS3A amplifier/power supply Amplitude Linearity: 1% up to 65 g peak Temperature Range: -40 to 82°C Temperature Sensitivity Effect: -54 to 38°C: ≤5% FS; 38 to 121°C: ≤8% FS Thermal Shock: 1.2 g/°C Transverse Sensitivity: 7% of axial max Maximum g Without Damage: 5000 g peak Maximum g Without Clipping: 75 g peak Mounted Resonance Frequency: >23 kHz nominal Output Impedance: 200 Ω nominal Bias Voltage: 13 V nominal Base Strain: 0.04 g/microstrain nominal Noise Floor (Wideband): 0.0003 g (rms) Weight: 50 g nominal (without cable) Material: Inner Housing: 303 SS Outer Jacket: Non-conductive composite polymer Dimensions: 2.16 H x 2.54 cm D Connector: 3 metre integral coaxial cable to BNCM Mounting: 10-32 removable stud Mounting Torque Max: 22 cm-kg (20 in-lb)