Cookies på Omegas websteder
Vi anvender cookies på vores websted. Disse cookies er afgørende for, at webstedet kan fungere korrekt.
Hvis du fortsætter uden at ændre dine indstillinger, antager vi, at du gerne vil modtage alle de cookies, der anvendes på dette websted. Du finder flere oplysninger om cookies ved at klikke her
Luk
Kurv  |  Kontakt  | 
GRATIS TELEFON (Kun Danmark. Alle opkald besvares på engelsk) 80 25 14 43
INTERNATIONAL(+45) 80 25 14 43
Layer N Banner

Direct Mounting Signal Conditioners for FTB-930/940 Series Turbine Flowmeters  - Discontinued

FLSC-60 Series

Direct Mounting Signal Conditioners for FTB-930/940 Series Turbine Flowmeters | FLSC-60 Series

Se Alt Models Below

  • All units are suitable for direct mounting onto FTB-930/940 Series turbines

Beskrivelse

The FLSC series has been discontinued. Please contact our Flow Engineering department for a viable replacement.

All units are suitable for direct mounting onto FTB-930/940 Series turbines

MODEL FLSC-61
The FLSC-61 is a 3-wire analog transmitter designed to linearly convert a frequency input to an equivalent voltage output whose level is switch selectable @ 0-5 V/0-10 V. full scale frequency range of 75 Hz-10 kHz is jumper selectable. The span adjustment establishes the frequency point at which the full scale voltage output (5 V or 10 V) is achieved. A sensitivity adjustment permits the FLSC-61 to discriminate between a signal input or noise.

MODEL FLSC-62
The FLSC-62 is a 2-wire loop powered analog transmitter designed to linearly convert a frequency input to an equivalent 4-20 mA current output. A full scale frequency range of 100 Hz -10 kHz is switch selectable. The span adjustment establishes the frequency point at which a 20 mA output is achieved. A sensitivity adjustment permits the FLSC-62 to discriminate between signal input or noise.

MODEL FLSC-64
The FLSC-64 amplifies and conditions low-amplitude signals such as those developed by a magnetic pickup coil. The amplitude of the squarewave output equals the input supply voltage of the FLSC-64. A sensitivity adjustment permits the FLSC-64 to discriminate between an input signal and noise.The FLSC-64 contains a built-in test oscillator that enables the operator to verify the amplifier’s operation without a signal source. The power LED illuminates when the input supply voltage is present.
Til bestilling(Angiv modelnummer)
Vare nummer/Desc.
Antal 
Beskrivelse
Signal Conditioners
FLSC-61
Kontakt salgsafdelingen    
Beholdning: 
 
 
0-5/0-10 Volt output
FLSC-62A
Kontakt salgsafdelingen    
Beholdning: 
 
 
4-20 mA output
FLSC-64
Kontakt salgsafdelingen    
Beholdning: 
 
 
Frequency amplifier
All amounts shown in EUR
Noter: Comes complete with operator's manual.


We noticed you are from the US. Visit your local site for regional offers and live support.