Cookies på Omegas websteder
Vi anvender cookies på vores websted. Disse cookies er afgørende for, at webstedet kan fungere korrekt.
Hvis du fortsætter uden at ændre dine indstillinger, antager vi, at du gerne vil modtage alle de cookies, der anvendes på dette websted. Du finder flere oplysninger om cookies ved at klikke her
Luk
Kurv  |  Kontakt  | 
GRATIS TELEFON (Kun Danmark. Alle opkald besvares på engelsk) 80 25 14 43
INTERNATIONAL(+45) 80 25 14 43
Layer N Banner

Linear Diaphragm Karma Strain Gauges

SGK Series

Linear Diaphragm Karma Strain Gauges | SGK Series

Linear Diaphragm Karma Strain Gauges

Se Alt Models Below

  • Full Bridge Gauge on one carrier
  • K-Series Premium Karma Strain Gages
  • Stock Delivery with Solder Pads
  • Good Linearity Over Wide Temperature Range -75 to 200°C
  • Good Fatigue Life
  • Custom Gauges Available
Belastningsmålere, tilbehør og instrumenter - Vis relaterede produkter

Beskrivelse

Find how a Strain Gauge works on this link.

The linear pattern strain gauges are used to measure strain in a single direction. The strain gauge pattern is shown on the left side of the table. Notice the "arrow" which indicates the principal stress direction.

The linear pattern strain gauges are available in a variety of styles and sizes. OMEGADYNE® offers miniature linear patterns for strain measurement of a stress concentration or high gradient areas. The terminations are offered both at one end of the grid, or with one at each end of the grid. Wide or narrow linear grid patterns are available. To determine if the strain gages have ribbon leads or solder pads, see the column labeled "TERM" short for termination, "L" indicates ribbon leads, and "SP" indicates solder pads. To determine if the strain gauges have temperature characteristics matched to steel or aluminium, see the column labeled "COMP" short for compensation, "ST" indicates steel, "AL" indicates aluminium. See the column labeled "BTP" for accessory bondable terminal pad model numbers.

Dimensions are listed for pattern gauge grid length (A) and width (B), and the matrix or carrier length (C) and width (D). The patterns include alignment triangles and letter codes indicating creep code.

For examples of actual strain gauge applications please see our Guide to strain gauge installations

For more in-depth application details and formulae see our guide on How to position strain gauges to monitor bending, axial, shear and torsional loads

We also have General information on strain gauge installation

Til bestilling(Angiv modelnummer)
Vare nummer/Desc.
Antal 
Beskrivelse
Sold in Packages of 5 Gages
SGK-LD1B-K350Q-PC11-E
Kontakt salgsafdelingen    
Beholdning: 
 
 
Linear diaphragm full bridge, 350 ohms, compensated for steel
SGK-LD1B-K350Q-PC23-E
Kontakt salgsafdelingen    
Beholdning: 
 
 
Linear Diaphragm full bridge, 350 ohms, compensated for aluminum
All amounts shown in EUR
We noticed you are from the US. Visit your local site for regional offers and live support.